Why would a neighbor on a point to point T1 have a priority of 0 when there is no priority configured on the serial interface? For example:Router2#sh ip ospf neiNeighbor ID Pri State Dead Time Address Interface10.192.254.7 ...

I have a vendor who has installed an "isolated" (not connected to me) network at 2 of my sites which are connected to my WAN. He wants the application that runs on each of these networks to be accessible from each site. In most situations, I could ...

I am finding confusing information regarding the distance limitations of coax (734, 728, etc.) when using the PA-T3+. I have found the following in documentation:"The typical maximum distance between stations for T3+ transmissions is up to 450 feet ...