Looking at a small deployment of 1121s (4ea) in autonomous mode, with about 40 users. Current configuration uses WEP. Looking to migrate to PEAP w/MSCHAP-v2. For test purposes we have set up another AP with PEAP and have it working. Question is, ...
Have a scenario where a 3rd controller is to added at a site. What pit-falls do I have to look forward to if I copy the config from an active controller to the new controller and the add it to the network. All of this assumes that before connecting...
I'm sure this has been covered in the past, but I've not been able to find the discussion.I'm looking for a configuration example that supports WEP on one SSID, and WPA-PSK on a second SSID, where each SSID is on a seperate VLAN.
Looking for config assistance on a couple of 2811s, connected via a T1 that will carry voice traffic between 2 Nortel Option 11c's. Will 'auto qos voip trust' on the serial interfaces suffice?Does a 'map' function need to be defined?
IF I can hijack this . . . Ran into an issue with ether-channels/port-channels on a 4506 and a 3560. 3560 died - PS failed. Replaced 3560 with an identically configed 3560 to the same physical ports on the 4506. Now I have no connectivity. I do s...
Thanks for the links. From the server side (IAS) I believe that I have everything setup correctly. My follow-on questions is what does the configuration on the AP look like when configured for PEAP-MS-CHAP-V2 or EAP-TLS? An example would of great ...