This article used a translator.
My N7k the bootflash has been corrupted.This has been confirmed as follows.This damage is going to use the recovery tools. (N7000-s2-flash-recovery-tool.10.0.2.tar)But you can not use the NPE.Tell us how
-----------In ...
Good morningI'm using a translator. catalyst 2948g When telnet connection message "No memory for telnet process"The same phenomenon appears in eight devices. Is this a memory bug? * show cdp neighbors detail Port (Our Port): 2/49 Device-ID: JAB04...
This question is used a translator.... That caused the problem device "Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG2topology ----> Backbone switch - L2 switch - AP - deviceUsers use the DHCP.Users found the crash happened,...
This question is used a translator.... Current conditions - SW1 ----- Power injector ------ AP(cisco is not another model) - Port, AP, Power injector, Switch <-> Injector UTP cable Problems occur even after replacement - Power injector <->AP UTP ca...
Sorry .... I'm using a translator.....The wireless Internet users more than 10,000 people.The device is less than 10 may cause problems.The configuration is normal ....889b.39ff.0789 is Samsung mobile phones, this device can only issue ...Thank you f...
hi Thank you for your response.889b.39ff.0789 is the DHCP settings..... ;(Virus possibilities Perhaps ??I have seen a similar case.http://itknowledgeexchange.techtarget.com/network-technologies/solution-for-ip-4-dupaddr-duplicate-address-error-log-in...
