Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco Community, I have a question regarding Spanning tree tuning. We have a 3750 stack with both te interfaces towards our core (STP root). I need to tune STP so the root port will be te 2/0/1 and not Te1/0/1 (all ports have default config).I wou...
Hi dear cisco community, I have a setup with Cisco asa 8.4 and customers connecting towards a server in the inside interface.Everything workds very fine, the can reah all applications and stuff, BUT, the ICMP would not go through.I doucble checke, se...
Hi there, i have issues in configuring a L2L ipsec tunnel with my 1921 and ASA.I have to use the aggressive mode as the 1921 does not any fixed IP. The IKE phase 1 goes well, but then i get the following message : 5 Apr 01 2014 11:00:14 713119 Group...
Hi community,I have an issue with connecting to my ASA using Anyconnect from a Winwows 2003 R2 SP2.User is connected with RDS on this machine and try to connect to the ASA with Anyconnect, but he gets the following error message :Feb 28 13:39:57 Berl...
Hi support community,I am experiencing an issue while trying to create some read-only users on my FWSM.I've setup the authentication on my RADIUS Server, which works fine, and put the aaa authorization command LOCAL command.I've also set the command...
Hi,
there is also CSCvd12371
Conditions:"ip ssh logging events" enabledRemote authentication.For radius - Radius-Server not sending back User-Name in Access-Accept.It can be seen also with TACACS.Workaround:Reconfigure radius to send User-Name in A...
Hi PAulo, thank you very much for this information. Any chance there is an official document that states such behaviour ? I believe this is not normal, it should use ports as they are used and not upon reservation. Best regards Florian
OK according to the guide :http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/12-2_55_se/configuration/guide/3750xscg/swstp.html#wp1020470 If your switch is a member of a switch stack, you must use the spanning-tr...
Hi marvin,
you pointed it right. i got confused with the ASDM, mixinf the transform set NAME and the parameters :
crypto ipsec ikev1 transform-set ESP-AES-256-SHA esp-aes-256 esp-sha-hmac
The same transform-set on the 1921 is :
crypto ipsec...
