Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, allI have one ASA 5510 with software 7.0, configurated as transparent firewall. Now I want to disable its stateful check, Anyone can tell me whether it support this feature? If its a routed firewall,can it support, And what is the command?Very Th...
Hi everyone,I have some question on unity:1, For configuring call transfer options on the User menu, there are two transfer type, that is 'Release to switch' and 'Supervise transfer'. I know Supervise transfer let unity play greeting when the phone i...
Hi, allI have found the following dial-peer in several case stadies. It match all called number, but there is not voice port configuration under it. So what is the effort for this dialpeer?---------------------!dial-peer voice 10 pots incoming called...
Hi, everyoneI have a problem with my LAN network. The core switch are two 3550 Switch, and several access switches 2950 connect to these 3550, each has one port to one 3550. So one port is SPT forwarding, another port is SPT block on each access swit...
Hi, everyoneI have a question about CAR on router. The router have a G703 E1 WAn interface and an ethernet interface. My goal is to rate-limiting access-rate of every ip address under ethernet, that is, for example, every PC under the ethernet interf...
imartinoVery thanks for your reply.1. From the explanation, it said nailed is used with 'failover timeout' command. What is that mean? I just want to disable the state check, so that asymmetric route traffic can pass through the pix. Can it support t...
Very Thanks for Rob's reply.Since Busy/unavaiable Greeting is determined by the call forward Busy and Call forward No answer setting under Callmanager, what is difference btw Release to Switch and Supervised under Unity?Tao
No, Strange symptom is the communication btw PC and PC is ok, so I guess there are just some wrong with this switch 2950's vlan 1. I found out the traffic on the interface vlan 1 is bigger than other switch. On this switch I found the 5 minute input...
FarrukhVery thanks for your reply.My purpose is to put a maximum access-rate limit for every PC in a LAN. So if there are 100 PCs in the LAN, with the above CAR, I have to make 100 ACL, as below:access-list 101 permit ip host 192.168.1.1 anyaccess-li...
