Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to configure QoS to prioritize Teams traffic. Is this config doing what I need to dopolicy-map PM_MS_TEAMS_OUTclass CM_MS_TEAMS_AUDIOpriority level 1police rate percent 10class CM_MS_TEAMS_VIDEOpriority level 2police rate percent 20class CM_MS...
I have a 4 switch 3850 stack on the 16.9.2 codeI'm building a new ISE server on 2.4 code (the production one is 2.2). My clients authenticate, reach the Posture-Unknown authorization profile, but then they don't get provisioned.This is the device tr...
I have configured wccp in my core switch, 4500x. My proxy is a McAfee Web Gateway.
The wccp configuration is pretty straightforward, and is working for my wired and VPN users.
It is not working for my wireless users. I have enabled wccp in the wirele...
Our 3850 stack is experiencing spikes on the CPU due to the eicored process. I have researched and cannot figure out what this process is for.
Core 0: CPU utilization for five seconds: 33%; one minute: 21%; five minutes: 20%Core 1: CPU utilization f...
I have a setup where I have a router(R1) that connects to two other routers(R2 and R3). I am trying to build eigrp active/standby neighborships in between R1, R2 and R3.
I have built the eigrp neighborship, but I need to figure out how to send a defa...
Thank you for sharing this. I have the exact same configuration except for the chain validation and revocation check. I have set both none. Sometimes I get a page saying you have been logged out, click here to log back in and it goes back to the erro...
Ah, I see. I am not in the same situation. My provider facing interface is 10g and my bw is 10g. This has been very helpful. Appreciate your help and quick replies
Thank you, seeing that we are maximizing our circuit, shaping should help. But from what I'm understanding correctly the shape average value should be 100.
