Does CER support use of CAMA trunks to pass location/floor info?This would be for a 2800 router which I understand now has software conversion of FXO ports. Does it matter if gateway configured as H323 or MGCP?
I have 6509 and 3750 switches and I am looking for the minimum configuration to get MOH to work for CM and phones. I can put "spare-dense" mode but am worried that dense will flood the network. Also I see that there are about 3 different pim-sparse...
After completing CER database, how do you get it to the PSAP?I have a U.S. legacy PBX that has E911 and it had to have the following: (1) a E911 monthly service added to existing PRIs and (2) a modem and software to upload changes. Do I have to keep...
It appears that in a 6509E there are 3 different backplane slots therefore certain modules can only go in certain slots. Is there a tool that will tell you which modules go in which slots? I have a SUP720, 10GE module, and FWSM.
Does CER allow the minimum configuration of just 1 DID per ERL? I would think the probability is low that 2 people would call 911 from the same floor and both hang up thus requiring a callback?
One-to-one static NAT for email server from public IP to private IP. This is in the dns/mx record. No PAT anywhere.All internal traffic to internet (including emails from Outlook client) go out ASA ethernet interface (different public IP).
What is the difference between untagged and tagged frames?The Linksys switch is attached to 2800 Cisco router ethernet port where I created sub-interfaces for dot1q trunk. I created vlan 1 native and vlan 2. (Router on a stick)In a Cisco 3560 switc...
