Ethan55
Level 1
Level 1
Member since ‎07-23-2018
‎08-11-2023

User Statistics

  • 21 Posts
  • 0 Solutions
  • 28 Helpful votes Given
  • 2 Helpful votes Received

User Activity

I have a simple topo as below:  R9 and R13 establish iBGP with RR. R9 is RR client of RR (10.10.10.10). R13 is a normal iBGP neighbor of RR.I use OSPF and LDP.R9 and R13 have VRF VPNA and exchange Lo1 as the VPNv4 route. Do Next-hop self in RR.R13 an...
Hi all guys,I have a simple static NAT config.TopoClient (f0/1) ----192.168.0.0/24----(f0/1)R1(f0/0)----200.0.0.0/24----(f0/0)R2IP addressesIP Client:f0/1: 192.168.0.10/24IP R1:f0/1: 192.168.0.1/24f0/0: 200.0.0.1/24IP R2:f0/0: 200.0.0.10/24 ConfigCli...
Hi all,I have read default Engine ID follow bellow format:- First 4 octets—First bit = 1, the rest is the IANA enterprise number.- Fifth octet—Set to 3 to indicate the MAC address that follows.- Last 6 octets—MAC address of the switchBut after config...
Hi all, When I enter show interface interface_name on Cisco device (ASR901), I see that: PE3#show interfaces g0/3GigabitEthernet0/3 is up, line protocol is up (connected)  Hardware is Gigabit Ethernet, address is f40f.1be8.50bb (b i a f40f.1be8.50bb)...
Community Statistics
Member Since ‎07-23-2018 01:41 AM
Date Last Visited ‎08-11-2023 07:23 PM
Posts 21
Total Helpful Votes Received 2
Helpful Votes From