Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, one question, does the Switch C9200CX-12T-2X2G-A support Layer 3 configurations ?, such as static routes or something basic with dynamic routing such as OSPF? Reviewing the configuration guide, it sees that it is, but if I look at t...
Hi everyone.
I have a two nexus 5596 with unified port, I am using NPIV and FCOE, the VFC ports work correctly, however when you want to use the FC ports, they remain infinitely UP / DOWN.
2018 Apr 2 14:21:46 Nexus1 last message repeated 1 time2018...
Hi all, I have a problem with the integration of 2 nexus 5000 with brocade SAN Switch. I set NPV + FCoE, but I was reading the papers for these configurations and Cisco is the question I want to create areas where I can not. The servers are connected...
Estimados, Tengo problemas para autenticarme con un IPS 4240, si lo intento por telnet o ssh me pide usuario y contraseña pero no me deja entrar.Me conecte por consola, por suerte estaba la sesion abierta pero no me deja modificar o cre...
Dear Walter:
- It is correct that things are very different, I just want to say that what goes with FCoE works well.
-I have connected all FC and FCOE hosts to the same Nexus switches, my problem is with FC host (Tape Library and backup Equipment...
Carlos: I am using NPIV and FCoE, not NPV.. so I can only configure the following:
Nexus_A(config)# int fc 4/12 Nexus_A(config-if)# switchport mode ?E E modeF F modeSD SD modeauto Auto mode
