Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I need to know if it is possible to perform proxy radius based on the realm, directly from the AP/Controller, as I have no Radius Server to perform this function. I know other vendors can, but I have searched into documentation, but i found no...
Hello,I need to access to the complete list of multicast subscribers for one VLAN, not just the last reporter.Does anybody know how to get it through commands or SNMP?Regards
Does anybody knows how to configure W2K clients to work through a NAT device? I have them working with public IPs, but I cannot make them work with a private IP (only one client per NAT device)I have already activated NAT-T, but I get one of this mes...
Hi all,I am trying to start a tunnel using a certificate stored on a GEMSAFE SmartCard before logging in, in oprder to propperly log onto the network using my certificate, but The Cisco VPN Client v3.6 says:"The currently selected profile uses the Mi...
Hi all,While coinfiguring a VPN3015 via HTTP, user is disconnected and in my syslog server appears a message "Connection not accepted, too many existing connections", but just one or two HTTP sessions running.Even if I logoff via Telnet every HTTP se...
Hello Susendra,There are several RADIUS servers, but they are external, and I need to authenticate external users from those RADIUS, so I need to do Proxy Radius directly in the WLC. Is it possible?I haven't found any doc about this.Regards.
Hi Wei,I had already read that article, but other MS articles and Cisco Support pages say it is possible to do it.I've just opened a case at Microsoft to see what happens with this.I'll reply with the final answer.Thanks a lot.Best Regards. Oscar
First of all, thanks a lot.I've tried what you told me, but it still happens the same. The internal servers and PC's cannot see me in the neighborhood, and the cannot access to my local resources or printers.Internal DNSs and WINS servers map my comp...
Ivan,I suppose you want to deny access to the LAN (through a ALN switch). This can be done using 802.1x.This prevents users to get an IP address, or to use an static one until they successfully authenticate against an AAA server (ACS).Today it is onl...
