Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are try to re-insert a redundant Cat6500 Sup2MSFC2 into the active chassis, but after the module inserted into the chassis, it coz a network outage, as the active MSFC vlan interfaces do down and could not come up. And the same situation happen wh...
Hi,Need some advise to see whether it is hardware or other issue? I have a Pix 515 with Restricted license, the box come with 4 FE interfaces, and according to Cisco document, I should able to use 3 of them. But I can only see 2 interfaces in the con...
Hi all,Would appreciate if anyone can help me on this. I have a VPN3005 box, with public ip 210.187.x.y/27, and private ip 172.16.x.y/28. It use internal pool to assign the remote client under the range of 172.17.x.1-254/24. I have few servers (ip 13...
Hi,I am new to IP Telephony, I am just wondering is it possible to run a Cisco IP Phone (7940G and 7960G) without present of any CallManager or CallManager Express? I have heard from Cisco engineer from Malaysia that it might be able to work when usi...
Hi,I am working on the offsite of a small data center where they ultilize VPN 3000 box for the remote access VPN. The production network is using the VPN 3000 with the image version of 3.5.2. Recently, they have purchase a new VPN 3000 box for the of...
Hi Sebastian,Thanks for look into this case. Due to this is a production box, the owner does has a security concern on showing the config to others. So, I have cut out some related portion and mask the ip address when necessary.So, u may find the att...
I am not so sure the original version during the item purchased, it was a "pull back" item from customer about 1 year+.Thanks for all the advises.Regards.
Thanks for your reply. But I would like to apologize for not making things clear. Actually there are few Cisco IP Phones, a C3660 router with 4 FXS ports, an AS5350 with 4 E1 interfaces. All these connected to the same network segment.The requirement...
Hi,My email address is "[email protected]", I have yet to receive your image of the VPN3005 Concentrator, for the version 3.5.2.Do let me know where can I get it.Thanks and regards,Wei Ming, Wong.
I'm trying to install CDOne 5th edition on Win2K SP3. CiscoView is working fine. But, after installed the RME 3.4, it prompted an error message "cannot start daemon manager". I've tried to manually start the daemon at command prompt, but it was unsuc...
