About InternetB

InternetB · 10-07-2009

Hi, My question is based on the diagram attached. I have a dual 6500 series core switches, CR1 and CR2 whereby I priotize voice traffic upto 30MB as it leaves for the mpls cloud. Now the CRs are connected to 3650 switches. Would 'auto qos voip trust...

InternetB · 08-18-2009

Hi, I would like to confirm if I have a policy-map as shown below and if the voice traffic has reached 19 percent of the bandwidth and there is additional voice traffic coming in, these access voice traffic would be dropped isn't it ? policy-map TEST...

InternetB · 07-19-2009

Hi, I just want to check if I have a connection like this R1 -- R2 and it is running eBGP between them. R1 has a route-map outbound to R2 that gives different MED values for a bunch of routes. I shutdown the link on R1 going to R2. The bgp tabl...

InternetB · 07-14-2009

Hi, I want to clear the bgp table on this vrf. Here is how it looks like :- address-family ipv4 vrf mj redistribute connected neighbor 12.12.12.12 remote-as 1111 neighbor 12.12.12.12 activate neighbor 12.12.12.12 send-community neighbor 12.12.12.1...

InternetB · 07-13-2009

Hi, I would like to know what kind of STP can be used where the distribution switch is Cisco and the access-layer swithes are pro-curve switches. Is RSTP and MST the only option here. Currently my Cisco distribution is running pvst+.Pls advice,...

InternetB · 10-08-2009

Hey Edison, Thanks. How did you become so good mate ? Cheers,- sanjay -

InternetB · 10-07-2009

Hi Edison, Alright. What are my options here if I do not install the SIP/SPA or FlexWAN module to achieve the same result ? Or rather can I achieve the same results on the box without the additional module. Need to do some reading on thi...

InternetB · 07-14-2009

Hi Shivlu, To confirm, since my ASN is 1110, the 200 should be replaced with my ASN number of 1110 right ?Thank you,InternetB.

InternetB · 07-13-2009

This is what I have found out which says that MST is backword compatible with SPT/RSPT.http://www.hp.com/rnd/support/faqs/2510.htm#question5Q: Are there any special compatibility considerations to allow MSTP to interoperate with legacy STP or RSTP? I...

InternetB · 07-09-2009

Rick,Well if the aggregate-commands advertises the detailed routes and the summary route, what is the point of aggregating it in the first place ? I mean what is the benefit of doing this ?Thank you,InternetB.

Member Since	‎07-21-2008 01:04 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	77

User Statistics

User Activity

Re: QoS between Core Switch and Access Switch for Voice Traffic

Re: QoS and Class-map

Re: Route-maps and clearing BGP table.

Command to clear the bgp vrf table.

Re: Procurve Switch and Cisco Switch and STP.

Re: Re: QoS between Core Switch and Access Switch for Voice Traf

Re: Re: QoS between Core Switch and Access Switch for Voice Traf

Re: Command to clear the bgp vrf table.

Re: Re: Procurve Switch and Cisco Switch and STP.

Re: Re: Aggregate-address and aggregate-address summary-only