Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've got got an ASR 1001-X where I want to export netflow data to a collector connected to the Management-interface of the ASR.Here's my setup wrt netflow:flow exporter Flow-to-collector destination 192.168.1.99 vrf Mgmt-intf transport udp 2601 ex...
Hi,Having set up site-2-site IPSec-connections between IOS based routers for years I've now entered new terrains trying to set up an IPSec site-2-site-tunnel between a RV220W (Release 1.0.3.5) and a C1821 Router running IOS 12.4.(3b).For the setup: T...
Hi,I'm having a hard time trying to reset a 7960 to factory defaults as per http://www.cisco.com/en/US/products/hw/phones/ps379/products_tech_note09186a00800941bb.shtml#topic1First I power on the phone and immediately hit "#"The instructions say that...
Hi,I was looking for the latest firmware for the WAP121 AccessPoint. However on www.cisco.com under support I couldn't find any software for the WAP121 - all other Cisco WLAN APs seem to have their software there, but not the WAP121.Aren't the firmwa...
Hi,From our carrier we get a 2MBit line specified as "unframed G703". This line should be connected to two 2900-Routers (IOS 15.1) each equipped with a VWIC3-1MFT-G703-card.Being absolutely new to G703 I'm looking for a basic config so we can use tha...
Why by all means does a web conferencing solution like WebEx need access to the calender - even more when WebEx is open for "guest"? How does this go together with GDPR?? Speaking of: Can anybody from Cisco please comment on whether this is "only" a ...
