Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco Tandberg C40 codec and have been placing H.323 calls to an organization without any problems. The organization is now making changes and requiring that I connect to them with their new SIP address. When I try to connect, it immediate...
I have an AP group on a Cisco 5508 WLAN controller. Currently, it is populated with 13 Cisco 1142 lightweight access points. When I try to add a Cisco 3602i access point to the group, I get the following error in NCS: Error: OfficeExtend requires ...
I am preparing to set up guest wireless access in a dorm environment with a Cisco 5508 WLAN controller and Cisco 3602i APs. According to the book I've been reading, it recommends that I set up a WLAN for 802.11a/n clients in the 5 GHz range and anot...
Turns out I had to turn "TLS Verify" to "Off" and my call went through. Using another test URI I was able to finally pinpoint this. Thanks to everyone for the troubleshooting help.
I do have a standalone box as Martin referred to above. I have SIP enabled and have entered an external DNS server but still can't call a SIP address with a URI. Any other ideas?
I did an audit on the controller from NCS and there was an "Office Extend AP" attribute mismatch. Not sure how this happened, but I set it to match the controller and all is well. Thanks!
