Hello Community,
I have one question.
It is possible to configure Dual-Active Detection fast-hello on Port-channel?
If yes, what is the maximum authorize link?
Hi All,
When connect via Remote Access to my corporate network, My Cisco Anyconnect Client is unable to resolve internal server name. My ipconfig /all doesn't show any line that have with my dns server value.
thanks in advance for your response
Dear all,
we have 4 switch with 2 in VSS mode :
- 2x WS-C6509-E (in VSS)
- 2x WS-C4510R+E (in VSS)
When configuring etherchannel between them, we get the following error :
*Apr 12 03:44:44: %LINK-3-UPDOWN: Interface GigabitEthernet1/1/10, chang...
Hi All,I try to enter in CICM mode to install Cisco ISE 2.3 but the credential doesn't pass. I try the following combinasons : admin/Password, admin/password, admin/Cisco12345, admin/cisco12345, admin/adminCAN Someone help me, please?
@balaji.bandi no worry.I saw that it is only possible to configure port-channel on physical interface.So if you have more that one Dual-Active fast-hello links, what is the behavior during a failed supervisor detection?
Already try to do it via MSI way but the anyconnect module (Version 4.6) is not able to contact the PSN.We did a RollBack to Anyconnect 4.3 and compliance module 3.6.
Hello,
Now using Anyconnect 4.6 but always the same issue.
On the ASA, I'm using external group-Policy that are configured on ISE with the following value :
* DACL = MY_DACL * Class = MY_GROUP_POLICY * CVPN3000/ASA/PIX7x-Primary-DNS = X.X.X.X *...