cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

367
Views
5
Helpful
5
Replies
Enthusiast

cisco 4500 VSS Dual-Active fast-hello Port-channel ?

Hello Community,

 

I have one question.

It is possible to configure Dual-Active Detection fast-hello on Port-channel?

If yes, what is the maximum authorize link?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Expert

Re: cisco 4500 VSS Dual-Active fast-hello Port-channel ?

dual-active fast-hello command is not available under  Portchannel interfaces. It is only available under physical interfaces.

HTH

View solution in original post

5 REPLIES 5
Highlighted
VIP Advisor

Re: cisco 4500 VSS Dual-Active fast-hello Port-channel ?

 @issmoussa1

 

Sorry for my earlier input to your question, after @RezaSharifi posted, i looked at the CVD and documentation. so edited this post.

 

@Reza Sharifi

Thank you for the correction,

 

BB

BB
*** Rate All Helpful Responses ***
Enthusiast

Re: cisco 4500 VSS Dual-Active fast-hello Port-channel ?

Thank you very much! Will try it on Monday.
VIP Expert

Re: cisco 4500 VSS Dual-Active fast-hello Port-channel ?

dual-active fast-hello command is not available under  Portchannel interfaces. It is only available under physical interfaces.

HTH

View solution in original post

Enthusiast

Re: cisco 4500 VSS Dual-Active fast-hello Port-channel ?

@balaji.bandi no worry.
I saw that it is only possible to configure port-channel on physical interface.
So if you have more that one Dual-Active fast-hello links, what is the behavior during a failed supervisor detection?
VIP Expert

Re: cisco 4500 VSS Dual-Active fast-hello Port-channel ?

It really doesn't matter how many fast-hello links you have when the sup fails in one chassis.  For example, as soon as the sup fails in chassis-1 all traffic will be forward by the chassis-2.  So, when sup fails, the whole chassis is dead.

HTH

CreatePlease to create content
Content for Community-Ad