Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
We plan to do an IOS upgrade in our Cisco Catalyst 6500, but this time, the upgrade includes a change of version, moving from 12.2.33 to 15.1. Anyone knows any issues i have to take into account in order to do this or I can perform the upgrade in...
HiI need to config an old Cisco 3560 in order to establish a BGP session, my new local AS is higher than 65535. I have tested several IOS but none of then has support for this.According with Cisco documentation:In Cisco IOS Release 12.0(32)SY8, 12.0(...
Hi,We have purchase a MCS7816-I4 CCX1, and have notice that the server has only one hard disk (the last time we say yes to a Cisco engineer without check)I was wondering if is it posiible to puerchase a sencond HDD a configure RAID 1 between the two ...
Hi, I have several SGE2000 in production and every night I save the current configuration to a tftf server... from time to time I get the following error:20-Oct-2010 11:29:00 %TFTP-C-OPEN: No free UDP port20-Oct-2010 11:29:00 %COPY-W-TRAP: The copy o...
Hi, I have a Call Manager 5.1 and I would like to configure a SIP trunk to a voip service provider via Internet directly (not using the gateway).To access the service I need to provide a username and a password to the provider, but there are no boxe...
Hi, I understand what a vlan domain is, my problems is when a server produce traffic, all this traffic is replacated to all the ports of the same vlan.... like a hub does. I thought the SGE was a switch, and the traffic would go only to the destinati...
Hi, I am getting the same response.... as soon as I configure the vlan in a port, the swicth seems to create a hub per vlan... and if you open a TAC with this problem, you only get, rebuild all the configuration from the beginning and let us know if ...
Hi,Thanks for your answer, we were going to purhcase the second disk, but we did not knok if we need for an extra SAS/SATA controller for the this "IBM" server.We are currently migrating from 4.1 to a 8.0Thanks in advance.
