DavideL3
Level 1
Level 1
Member since ‎11-15-2018
‎03-09-2021

User Statistics

  • 12 Posts
  • 2 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies
1 Accepted Solution

User Activity

Hello everyone,I would like to know what's the best pratice to set up queue limits on ASR1000 as BNG role.I reviewed Cisco documentation but I need expamples from real world.Imagine an ASR1000 acting as BNG where 500/1000 PPPoE Internet service termi...
Hello,I have a weird problem.I set up 6PE using an old ASR1000 as route-reflector.  (IOS XE version 03.16.09.S).The RR eceive prefixes from 6PE enable routers and reflect them correctly.If I try to configure an outgoing route-map to a specific peer t...
Hello,I have an issue with ASR-920-24SZ-M.After about 2 week of uptime and  the device reboots with reason: "RP-Reset".I only found the attched file into bootflash:/core/ directory: kernel.rp_RP-PEGM_0_20191229200139.I think these lines report eviden...
Hello,I'm testing 2 ASR-920-24SZ-M with XE 16.09.03 version.The devices are connected back-to-back using Teng 0/0/25 interfaces with MPLS enabled.The TenG0/0/27 of both devices are connected to traffic generator instruments.Here's the setup:There is ...
Hello,when reading documentation about optical amplifesr I see always two values:xx dB in gain mode xx dB in power modeSomeoune could explain me the difference ?Thanks!D.
Community Statistics
Member Since ‎11-15-2018 02:00 AM
Date Last Visited ‎03-09-2021 05:46 AM
Posts 12