Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have two 3640 routers with E1 modules installed, a back to back ISDN cable and can get ISDN L3 up and running OK.when I change over to using MGCP I cannot get isdn L3 (multiple frames established) in show isdn status.Below is the working output,...
Hi, I have a 1801 ADSL router. I have a Bridge group 2 configure with a BVI interface, this is also bridge onto VLAN 2 so I have a server on VLAN 2 which acts as a media server.when I connect to the WLAN I can get to the internet. But cannot connect ...
Look into glbp gateway load balancing protocol. This can be used for outbound balancing. I use the term balancing loosely. For inbound depends on the wan protocol Sent from Cisco Technical Support iPhone App
Thanks,I am still not sure what exactly i done to get it to register, but the key point wasCurrent active Call Manager: NONEBrokenThis is nowCurrent active Call Manager: 10.100.9.11ThanksJohn
Hi,Just some notes.The servers have dual connectionsn to the network. Genrally one will be active (sometimes both) but if you use GLBP gateway then there is every potential for them to hit the Left L3 switch go across the trunk to the Right L3 switch...
