bozo.bogd
Beginner
Beginner
Member since ‎12-05-2018
‎02-04-2022

User Statistics

  • 14 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
5 Replies
Certifications

User Activity

Hello, I am having strange connection drops once I configure custom RF profile which is set to Channel Width 40Mhz and apply it to ap-group. Its not caused by long distance from access-point. Goal is of this change is of course to increase throughput...
Hey guys, I am currently trying to setup IPv6 DMVPN alongside IPV4 DMVPN, in order to pass both address families. However there is no IPv6 NHRP command under tunnel interface.  I am able to create BGP peering in both address families just using IPV4,...
Hi guys, I seem to have an issue with control-plane policing with ASR-920-24SZ-M. Configuration is accepted, applied but traffic just doesn't hit it. I'am running version asr920-universalk9_npe.16.09.05f.SPA.binACL's are simplified as much as they ca...
Hello, I need your help to figure out how to mirror configuration known to me (IOS) to this new IOX-XE box I want to replace one 3750 core switch with ASR920 but with bunch of vlan's and trunk's became tricky as it seems. For example : 3750 : interfa...
Hello,Please help me understand how to mirror this config from IOS to - IOS XE Cisco IOS XE Software, Version 03.18.02.SP.156-2.SP2-extinterface GigabitEthernet0/1mtu 1998no ip addressload-interval 30tx-ring-limit 5media-type rj45speed 1000duplex ful...
Community Statistics
Member Since ‎12-05-2018 12:41 AM
Date Last Visited ‎02-04-2022 05:42 AM
Posts 14