Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, everyone! I was in a situation little bit difficult, two old HP servers with vmware hypervisor 5.5, configured from another network! (have no idea about the config)i had to backup the servers and i had no [username, password, ip address and NO VG...
Hi,i have a stange issue, i can not boot on rommom.once i power on the switch,the led are not stableno view in the puttythe fun is making soundis this an hardware issue ?
hi everyone !i wanted to change the 802.1x password but the text_ (security onggle on wlan) bar does not exist on the wlc 2504 GUI !is there a command to change the 802.1x password on the 2504 wlc version 8.3 ?best regards !
Hey Everyone !I'm working on a C2960x. I've configured VACL for NO browsing and it works fine. Unless, there is no available show command, and it is strange!Also, the Key_word "Log" does not work with the associated ACL !So, how can I verify the matc...
Hi Everyone,Can i syslog the calls without using AAA Accounting ? if yes, how?NB :: i'm receiving other syslog MSGs But not the one's for calls ! Best Regards !
hidot.1x for users (there are different wlan and different passwords | no remote server is used for authentication so => locally used)no label text is viewed => mot like WPA and psk ...Thanks
Hi,i'm using regex to filter show commands this time !. it works almost fine, just for some cases ::* the digits specification \d does not work* how to escape characters \.* how to use ?=non-greedy as it is considered as help on cisco iOS* is it pos...
Thank you all for your replies!my issue was not how to configure static pool ! but what is the #DHCP_ID_Type.After some Show commands, i found a display_problem. the Client_identifier is may be large to display it on a single line!it's on the format...
