Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I feel stuck trying to configure our SG350-28P. My SG350-28P is connected to our datacenter 3560X via fiber. I am able to remotely access the switch via SSH and HTTPS so I know connectivity back to the primary switch is good.
However, I cann...
We have had ongoing issues with not being able to send/receive faxes reliably since we've installed this new phones system (previously we were on a Nortel system).We are trying to fax using HP 4345 MFP, HP 3035 MPF, Richo MP 171.Often faxes fail to s...
Hello All. I tried to setup my SG300-28P similarly to my 2960S but using the following commands:conf tint range gi1-28auto qos voip cisco-phoneBut there is no similar command that I can find on the SG300. Is anyone familiar with a similar command? ...
I am looking at purchasing a new phone system for my company very soon. I have looked at a few options (Shoretel, ShoretelSky, Allworx, Mitel). I have been talking with Cisco and we are having a hard time understanding how we (myself, re-seller & l...
I added the network-clock-select command. I haven't seen anymore slip errors since but I'm not sure how much activity is on our phones today.I also found that my ATA devices were configured for T.38 but the gateway was configured for pass through. ...
rplus-2911-1#show controller t1T1 0/0/0 is up. Applique type is Channelized T1 Cablelength is long 0db No alarms detected. alarm-trigger is not set Soaking time: 3, Clearance time: 10 AIS State:Clear LOS State:Clear LOF State:Clear Version i...
