Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,After installing the New Cisco LMS (Version 4.0) I am facing the following problems that need to be resolved.1.Leased line connectivity from Central router to remote locations are showing as cloud.In earlier version this is not showing.2.How to g...
Hi,I have cisco 2350 switch and trying to configure port security.Could any body confirm that wherther it is the hardware limitation,if not what could be the possible reason.I have tried with different ios still no luck.I have gone through the config...
Hi,I am using LMS 3.2 and DFM 3.2.0Problem belongs to DFM Email notificationAfter configuring event sets & email notification for devices, i am geting mail when a switch port DOWN. but when this port is UP, i am not getting any email notification.Ple...
Hi,We are facing high CPU utilization on 3750 due to the process hl3mm.Please find the output of show process cpu sorted,show process cpu and show version attached here.Please helpIkbal
Hi,I have newly installed LMS 3.2.But device status in DFM shows "learning" state and 10% completed.Here attaching the screen shotDFM 3.2.0common services 3.3.0RME 4.3.0LMS is running on Windows platform.I am not using any .Net2.0 SP 1 update.Resta...
3750x 12.2 55(SE) won'tsupport show ip cahce flow or show ip accounting. Better get in touch with ISP to provide top talkers during the time high traffic happens.Otherwise you have to go with SPAN session of the port
where are you configuring ip cache flow commoand? your switch is connected to ISP router? do you have access to ISP Router. If it is connectedre to ISP router and have access , configure the command under the interface of the router where the switc...
You can check CPU utilization of the device using the command show process cpu. If it is normal you can configure ip route cache-flow under the physical interface of other end device(May be router or Core switch).Then use the commandshow ip cache flo...
If the port 48 is configured as a routed port enable ip cache flow at the other end of the switch and check the output of show ip cache flow . You can see the source and destination ip addres details with the utilization
