Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I have implemented dual ISP routing on ASA firewall and faced a problem with a VPN tunnel.- Pre-implementation state:The firewall had one outgoing interface ("outside"). Several VPN tunnels were built over it. The most part of Internet traffic ...
Hello! I have a stack of 3 Catalyst 9300 switches and have to connect 2 other to the stack.Output "sh version" from the stack showsCisco IOS XE Software, Version 16.12.02Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IOSXE), Versi...
Hello! We have ACI Multi-POD with 3 PODs inside. The 3rd POD should be decommissioned. It doesn't have any L3out config, but it has L2 extension. I am going to decomm switches with "Remove from controller" action. What configs and policies should I c...
We faced similar problem in System version: 14.1(1j) with N9K-C93180YC-EXWhen the console port on the back of the ACI leaf is connected via a cableto the port of Terminal Server CISCO ISR4321, the ACI Leaf refuses to startup and is stuck in loader, w...
Hello! I booked ACI HW lab but there was only APIC in topology and there were not leaf and spine switches like it was shown on network diagram. So it was like playing with ACI Simulator. Is there any hope to see HW in lab? Does anyone know about th...
Hello! Information is old in the article, options for booking are different now.What options should I choose for building my own topology? Popup window tells that I can choose [any] not to have initial topology, but "reserve" button disappears with ...
Hello!I have a question about these two strings in payload: "tnFvBDName": "BD-sample", "status": "created,modified"BD-sample - Is it a name of Bridge Domain which has been already created and EPG is associated with? So it also shoul...
