Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , I am trying to PnP provision a new 3802i AP (which I upgraded from 8.2 to 8.3 release in order to get PnP to function) with PI3.1.6 integrated with APIC-EM 1.4.2 with a new config. For some reason it's not properly getting through and stopping t...
Hello,I'm just wondering if it is possible to change a setting on a Cat4500 switch (like "no ip policy route-map.....") using SNMP. I would like to automize that, so in a certain situation this route-map command on the Cat4500 should be disabled. Who...
We would like to connect Cisco IP phones to a 3500XL switch using the Voice VLAN. If a PC is connected it should use VMPS to determine it's VLAN. Also I would like to have all PC's connected through the phone in the dynamic VLAN. Is this combination ...
Is it already possible to use VPN (IPsec) combination with Cisco firewall feature set and a routing protocol like OSPF?I know it is possible to use VPN + OSPF when using GRE, but then FFS is not supported....Thanks! Richard
Hi,The procedure worked fine for migrating from 7940 to 7960. I got some error message in BAT because phone was associated with 3 different users (for CTI reasons) but all settings were imported correctly except call-pickup group.both of you: thanks!...
