Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have switch cisco model 2960x with Version 15.2(6r)E, All the time ago the switch worked as fine without any any problem, Today i have issue and the issue happen less than five seconds and back worked again and since that the switch ...
Hello everyone,I can enter in ise server with GUI by used my username and password and can login as fine, But the CLI ssh i can't enter when i used my username and password, How can enable the account in cli?Any helpTHANKS
Hello everyone,I have 2 site and connected vpn by used firewall cisco, And have the problem every week repeated (TX go to zero), And I attached photo below: And after that can i solve the problem when i logout connection between the 2 site, But the s...
Hello everyone I have tunnel vpn between 2 branches and it's working fine but the services between them as voip server and can make call between 2 extension as 1 extension in branch 1 and other extension in branch 2,In asa sniffer I'm saw the error m...
Hello everyone, I have 2 branches connected by vpn with ASA cisco firewall "5506 x and 5526 x", setup with branches voip server Asterisk server,all configure as well working, The ip phone's calling in branch 1 as well and the audio working fine as lo...
Some time the connection it's disconnect for few minutes, When the vpn established the issue happened firewall A (10.10.53.12), Don't sent any traffic but received traffic from firewall B (10.10.53.30), I tried everything clear vpn session and clear ...
The device who was the problem in tx go to zero,The output is shown below, 10.10.53.12Ha#show crypto isa sa detailThere are no IKEv1 SAsIKEv2 SAs:Session-id:51, Status:UP-ACTIVE, IKE count:1, CHILD count:6Tunnel-id Local Remote Status Role277009347...
