neubar
Level 1
Level 1
Member since ‎06-22-2009
‎09-28-2022

User Statistics

  • 17 Posts
  • 0 Solutions
  • 4 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
10 Replies
5 Replies

User Activity

I see the release notes for Anyconnect version 4.0 are up and ISE 1.3 is also released (which can use Anconnect 4.0  for posture assessment) but all the download links point to Anyconnect 3.1. So where can I get the 4.0 client?
     I have a Call Manager 9.1.2 installation with all phones auto registered (using device mobility) and all the users enabled with extension mobility. This is great because phones only need to have extension mobility enabled before they can start b...
If I try a bulk insert of remote destinations that begin with a + sign (eg +15552125555) I get the following error: "A character to numeric conversion process failed"If i create the remote destination manually it works fine so I know that the string ...
I have the switch set up for mac notification, and the switch has the below config. But no mac notification traps get sent to the CAM.interface GigabitEthernet1/0/24 switchport access vlan 800 switchport mode access snmp trap mac-notification added s...
I have a recently installed CAM that doesn't have any rules or av lists so the drop down for av says update av list. when i go to the update tab I get a message saying it found no updates. The request is not timing out the message comes up instantly ...
Community Statistics
Member Since ‎06-22-2009 10:18 AM
Date Last Visited ‎09-28-2022 12:01 AM
Posts 17
Helpful Votes Given To