Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a Cisco Nexus C3064PQ, and I applied a policy-map on an interface, the policy-map contains multiple classes that match different source IP addresses.I want to capture the traffic of each class-map via PRTG, the sensors are detec...
Hello everyone,I have an issue with STP for the topology above, I need to run STP so that one of the customer's links will be in STP Alt state.The configuration is as follows:Site1-Eth1/1 (Towards Customer CE):switchport mode dot1q-tunnelswitchport a...
Hello Everyone, I want to create different NAT rules for the same source based on the destination. Assume that I have the private range 10.0.0.0/8 and I want to create two NAT rules as follows:if range 10.0.0.0/8 wants to reach ACL1 then use the publ...
Hello Everyone,I have an ASR1006 on which I've configured a virtual template for PPPoE connection and applied NAT config for the PPPoE clients to access the internet.Is there a way to create a destination NAT for all DNS traffic to be redirected t...
Hi everyone,I'm having an issue with QoS on bundle interfaces,assume that I have a four 10G interfaces bundled, the overall bandwidth will be 40G, but when I apply a QoS policy to limit the traffic on the bundle interface, the maximum limit that I ca...
The interfaces are bundled properly since the traffic is distributed among them normally, the only problem I'm facing is with the QoS policyI've faced this issue with two types of NCS (NCS5501, & NCS5700), both have the same problem, and they have di...
I have configured the FTP server with username and password using the commands (ip ftp username & ip ftp password). When I try to copy the config file to the FTP server a log message will show up saying (permission denied) even though I made sure tha...
This Is The Error I'm Getting, Also This Is Mentioned In Cisco's Official Get Cert And All Over The Internet, But I Haven't Seen Any Explanation To Why It's Rejected.