Hello everyone,I have a Cisco Nexus C3064PQ, and I applied a policy-map on an interface, the policy-map contains multiple classes that match different source IP addresses.I want to capture the traffic of each class-map via PRTG, the sensors are detec...

Hello everyone,I have an issue with STP for the topology above, I need to run STP so that one of the customer's links will be in STP Alt state.The configuration is as follows:Site1-Eth1/1 (Towards Customer CE):switchport mode dot1q-tunnelswitchport a...

Hello Everyone, I want to create different NAT rules for the same source based on the destination. Assume that I have the private range 10.0.0.0/8 and I want to create two NAT rules as follows:if range 10.0.0.0/8 wants to reach ACL1 then use the publ...

Hello Everyone,I have an ASR1006 on which I've configured a virtual template for PPPoE connection and  applied NAT config for  the PPPoE clients to access the internet.Is there a  way to create a destination NAT for all DNS traffic to be redirected t...

Hi everyone,I'm having an issue with QoS on bundle interfaces,assume that I have a four 10G interfaces bundled, the overall bandwidth will be 40G, but when I apply a QoS policy to limit the traffic on the bundle interface, the maximum limit that I ca...