Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I've been struggling with this for hours and I can't seem to figure out what the problem is. The objective is to map network drives using the sbl script once a VPN connection is established on a client computer. Using anyconnect version 4.10. ...
Hi all, Im going to preface this with this disclaimer - im not an expert on Cisco networking (still learning), so bear with me if I dont provide the right details. We have a hub and spoke topology in our organization. Our field sites uses Cisco Firep...
Hi all, I have a Firepower 1010 in FTD mode managed by FMC. Its geographically located in an area with a slow wan connection (but has in the past been able to receive deployments). Firmware version is 7.2.5I have problems deploying to the FTD from F...
Hi Community! My organization has a hub and spoke configuration and one of the spokes (a firepower 1010) are on a slow wan link (they are in a very rural area and internet speed is terrible). Deployments from FMC to that device always reach 50% then ...
Hi community, I am working with an Aironet 1815i wireless access point and trying to add an SNMP community (V2c) but running into an issue. Its my understanding that you can use up to 32 characters for the name. the snmp community used at my organiz...
There are 2 dc's that basically mirror each other in configuration. field firewalls will connect typically to one of the s2s vpn firewalls in either dc. but im seeing (what seems random) is that while they are connected to one of the dc's, some routi...
Thanks balaji for the reply. Our FMC version is Version 7.4.1.1 (build 12). We have FTD's with version 7.2.5 up to 7.3.1.2 that work fine. FMC has been rebooted a number of times (to resolve other issues), but this one site continues to have problems...
Thanks Rich for the input. I do plan to upgrade the software. Will see if i can do the backup/restore operation. apart from that, I take it there's no other way around it? no CLI commands to run?
Thanks for the reply. We've been using snmp community with 7 characters on 800 series routers without issue. the snmp-agent command isnt available on the aironet 1815 access point
