Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am having an issue with adding a c3750x switch to an existing switch stackCurrently there is 2 x WS-C3750X-48P and I am trying to add another WS-C3750X-48P to this switchI have cabled the switch to the stack using the stack cables and added the c...
HiWe have a Cisco 877 router and also a 857 router and having a problem getting them to pickup a DSL signal. If I setup and configure the router at our office they pick up the DSL signal and work fine. However if I take them to the customers site t...
HiI have an issue with a UC540 and incoming calls when going to a hunt group. I have setup a sequential hunt group as I need to forward calls in a certain order. But when the first phone is in use within the hunt group the call is still going to th...
HiI am after advice on the best way to lock down a conference phone from being able to dial outbound calls without the user having to enter a PIN number first. The system is CUCM 8.5 and I am new to this system and after some advice on the best way ...
HiI fixed the issueIt looks as though the spare stackports on the existing stack were disabled. I manually enabled these stack ports and then restarted the new switch and it has now joined the stack.Thanks for your replies though
Hi BradIt does seem odd as I can see the phones were allowing 2 calls per button but are now on one call per button as your advice. All phones are SPA504GDale
Hi BradThanks for that, I have now configured the max-calls-per-button 1 on the phones. However it still doesn't notice the phones is busy. I have even given the phone system a reboot to see if that would cure the problemDale
HiThanks for the replyI have noticed the FAC code and I can see how that works, but how do i stop the extension from using 9 followed by the number which doesnt require a FAC code. Only allow the phone to be able to dial 7 followed by the number and...
Hi marcusThanks for that, needed to add a 90 as it is UK, BT seems to drop the leading 0 off the number and then if they click redial it all works fine now Thanks
