Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Csico switch 3750, when connect a device to this port, the light on the switch is green, but the device doesn't get IP, and doesn see it belongs to any VLAN in sh vlan.sh int g2/0/1 got:GigabitEthernet2/0/1 is down, line protocol is down (monitoring)...
ASA has L2tp IP sec configured, and it also provids real time VPN connetivity information, but not everyone is supposed to logon to ASA to check it out, I am wondering if there is a console (or something else) that can be installed on local machine...
user got disconnected and no luck in reconnecting back until 10 minutes later, ASA syslog shows : removing peer from correlator table failed, no match!googled the error message, "Most Common L2L and Remote Access IPsec VPN Troubleshooting Soluti...
CNA version is 7.5(6)router: Cisco 2951error: unable to connectare able to connect to other switches, such as 2970questions:1. is there any configuration needs to be done to connect to 2951 though CNA?2. is 2951 supported device in CNA?thanks. ...
am trying to backup confi to ftp, worked on one exact same model, but not this one, error is “%Error opening ftp://*****:*****@x.x.x/filename (Protocol error)” - can pint from router to ftp server - home directory leaves with default pathhelp...
thank you for reply, your help is greatly appreciated as you are the only one since I posted my question here( half month), and I am wondering if it's possible to use Microsoft RRAS (routing and remote access) to achive this goal? and one more thin...
do u mean a configuration on every switch & Router that needs to be able viewed by CNA? is the CLI standard or depends on the model? can u pls post the CLI here or direct me to the proper link? thx.error is "unable to connect", that's it
have been to those sites, not looking for generic information, and not sure about the compatibility between Microsoft & Cisco products either.thanks for response anyway.
can u pls provide me a little bit more info in regard to NPS? we do have RADIUS server setup, r u saying we need to use NPS to achieve the monitoring goal? do u have a link or something like that?thx.
having the similar question too, and noticed that the topic was posted last Dec, almost 1 year, no answer at all???Hi Sam, did u figure it out yet? could u pls share it with me? thx.
