Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I need to securely mount several phones (~20) to desks for a customer. The Cisco locking phone brackets are all seem designed for wall mount only. Has anyone found a bracket that works with a desk? Or have they modified the Cisco brackets to wo...
Hi there,My customer would like to trial a CCM solution and they are not in a position to upgrade to a license that allows Q.Sig. I have been trying to find a document that outlines the features of a plain ISDN integration vs QSig so they can know w...
Hi,I have been trying to migrate a Unity UM install from an ICS-7750 to MCS-7825H and ran into a real problem.The restore went ok and reported no errors. However after running DB Walker I got the following message:1392:(error) could not find local l...
Hi all,I have been unable to locate where I can change the mapping for Q and Z. It appears that they are currently mapped to the 1 key and this doesn't make much sense. I have done several searches on CCO but have been unable to find a solution.Any...
Hi all,I have a bit of a headscratcher. I am running Unity 4.04 with CCM 4.0(2). Unity is running VM only with 16 ports. Each time I reboot unity the first 2 ports fail to register. If I restart the unity services manually all the ports come up. ...
There is no message indicating that the ports didn't register. The only way I can see that they haven't registered is by going onto the CM and checking the status of the voice mail ports. The first always show as unregistered after a reboot. I did...
I have done this with an 804 router. This was in the days of ISDN being a fast internet connection. We would roll the fax line into the ISDN line so that any fax calls would come into the router and go out a voice port. Bringing down the second c...
Thanks, but I was hoping to do a purely IP integration without using voice gateways. I imagine H.323 would be the protocol to use as I believe the Nortel supports it.Anyone have any experience with this?
I am experiencing the exact same issue with a customer running an ICS. It very lightly loaded with 25 users, 20 softphone and 5 IP Phones. They have 2 PRI circuits. There is an MRP300 and an MRP200 running 12.2-11yv code. CM 3.3.3SR4I have troubl...
