Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Since we upgraded PI from 3.1.5 to 3.2.0.0.258 we get errors on every Site map which we created in PI 3.1.5 when we want to edit them. They are even not deletable. There are errors too, if you want to edit the map in the deprecated Site Maps In add...
Dear Community
Is there a way to create a Report in Cisco Prime 3.1 to get the same output as the command "show inventory" on Catalyst Switch?
Inventory, Detailed Hardware or Wired Detailed Device Inventory Report doesn't give me the result for all...
we just ran into the same yesterday, when setup and installing Cisco DNA center for the first time. we configred eno1 with default gateway, because we want this IP to communicate with our proxy. we used the left 10Gb SFP enp94s0f0/enp69s0f0 (step 3 ...
In our case it was a combination of global enabled "ip dhcp snooping" and "IPv6 source guard" on ports. After disabling dhcp snooping the switch did not Hang/Become unavailable at execution of "show run" any more.
We tried to upgrade to 16.6.4, but...
Since we have upgraded to 16.3.6 on our C3850-48P Stack and did a "show vlan" (before we deleted a vlan). SSH sessions locked.
Now we get " %SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input " and %EM-4-AGED: The specified EM client (EM_TYPE_VTP_DO...
Today we patched PI 3.2.1 and a few problems seemed to be solved. Maps are editable again, but we still can't add a new AP to an excisting map, which was created in PI 3.1.5. Device Groups dissappeared too and we have a clean inventory list now. Lets...
