Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As far as I'm aware basic QoS is provided in terms of egress queueing and priority. It doesn't have auto QoS.I need to amend the buffers defined for egress as per previous recomendations.This is a PoE switch so is expected to carry VoIP traffic, whi...
Hi there, I have some 2960 switches running the LAN lite image that are also experiancing drops on queue 4 for best effort traffic when QoS is enabled.We have upgraded the IOS to 12.2(58)SE1 but it hasn't resolved the issue.sh mls qos int fa0/1 buffe...
I had the same issue and it turns out the second dial peer is not used unless the SIP retry interval is set to 4 or less.The default is 6 so the rotary funtion doesn't work by default.The following command resolved the issue.sip-uaretry invite 3Here'...
If you have a shared SIP IP to IP gateway to your provider is it an option to register that gateway as your MTP device ?Utilise software MTP rather than hardware so as not to use DSP's.That should enable the external interface to communicate with you...
Hi, You'll definitely need a Loopback address and the 'h323-gateway voip bind srcaddr' configured under the loopback interface. The 'ccm-manager music-on-hold' command will also be required.If you use the 'show ccm-manager music-on-hold' command it s...
