Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am planning a new CUCM environment with an ITSP that will connect via a CUBE. CUCM <-> CUBE <-> ITSP, it looks like I will need the CUBE-T-RED license. The two questions I have are do I need 40x licenses per HA pair for 40 trunk sessions? My resell...
Hello Support Community,
I'm trying to figure out how to configure the ports on a Cisco SG200-8P for data and voice vlan.
Whereas, the enterprise grade equipment offers command line and does not require any fiddling with GUI, I'd like to accomplish s...
Hello,
We are trying to figure out the best method for failing over to providers if one is down. We have CM 11.5 with a SIP trunk to a pair of 4K routers in HA. The users calling number are using their DID. The issue I see is if their ITSP (ITSP-A)...
Hi community,
In the upgrade guide for CER it says you need to upgrade CER first. Is that a hard requirement? Does anyone know whey that is? I thought CER was an auxiliary component.
You must upgrade Emergency Responder before you upgrade Unified C...
Hi all,
I am setting up a 3 node CM and 2 node IM&P environment. I am looking to figure out how to get the SRV records setup properly for the integration. I have the SRV records created but I'm not sure how this should be done properly. The document...
Hi Mike, I have. We are a MSP and a Cisco partner. It's a lot of infrastructure to stand up for my needs. I would like to build and manage it myself. VMware Cloud looks like a good fit, Webex Calling is limited and HCS seems to be a big undertaking. ...
I can confirm it doesn't route via the routing table. The default behavior is not scalable. I would like to not have to pin it to an interface so I can still use TACACS+ when the primary interface or ISP is down. The command will not take if your TAC...
