Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we are currently testing the SBL feature of the AnyConnect client on notebooks. There have also deployed SafeGuard, a full-disk encryption software which also relies on there own GINA dll.Anybody a clue, how to solve such issues? Is there anyth...
Hi all,we are implementing Cisco WAAS (or another cache engine) and need to redirect traffic within one VRF via VRF-aware Policy based Routing (PBR). Mainly everything was configured according the config guide at http://www.cisco.com/en/US/docs/ios/m...
Hello,if got one 7940 that is not able to load its firmware. It curretly reboots constantly showing:[Universal Application Load 2000-2007)Configuring VLANConfiguring IPCopying to Bank1Load upgrade complete..reboot..All phones are loading there config...
Recently we changed a Linux router to a Cisco ASA 5505. We do have a dsl uplink with a PPPoE reconnect every 24 hours.Behind the ASA at the LAN there is a SIP phone connected (Siemens SL75) to a public SIP provider in the internet (SIPgate.de). After...
After upgrading LMS 3.0 to 3.1 everything went fine. Updates also to with the lastest patches.Sadly I am now unable to open the CommonServices Portal Page (https://<host>/cwportal/c/portal/layout?p_l_id=PRI.3.9). It's always loading without any retur...
Thanks for your answer. In my particilar case the issue is not about starting the AnyConnect SBL GINA. Is has been sucessfully installed, as well as AnyConnect and the profile.The issue is about having another conflicting GINA allready on the same Wi...
Thanks for your reply and hint. Tested again both variants. Sadly only the the second ("set ip vrf office next-hop...") will redirect the traffic. As soon as I add "set vrf office" all counters are raising, but no traffic will hit the pbr destination...
Worked also perfect here with WLC 5.1 and 1131 LWAPP:(Cisco Controller) >config ap led-state disable Additional questions1) I dind't found any show command, is there any?2) Is or will this also be able to change the led-status via the controller webi...
