HiI am using a Cisco ISR4331 as a PE MPLS router and wish to forward a vrf named TEST over multiple MPLS-TE tunnels.The 2 x MPLS-TE tunnels each go to different PE MPLS routers.Both MPLS TE tunnels are up and operational.Under ip vrf TEST I have used...
Hi,I am using a Cisco ISR 4331 router to act as a PE (Provide edge) mpls router.I am also using 2 Huawei NE40 routers as the P routers and also iBGP route reflectors.Within the MPLS domain I am using ISIS as my IGP.From an ISIS and iBGP persepctive a...
Hi From the LAN side of my CE (Customer Edge) router, I am able to ping and traceroute across my MPLS network to the other CE router on the LAN side. My VRF (METERING) is supposed to traverse an MPLS-TE tunnel (unidirectional) to the P router. As thi...
HiWe currently use the IR809 Cisco router for 3G/4G connectivity, no problems. We have since moved to the Cisco IR829 router.We have set this up as normal for mobile use but are having issues connecting to Telstra's mobile network.My understanding is...
The following is an extract of what I setup using C3745 routers in GNS3. This has been a workable solution:-The 2 serial links represent 2 x 2Mbps G.703 links over microwave radio links.I have created 2 logical tunnels which have both been IPSEC’ed.T...
Hi Just to let you know, I found the solution.After reading some literature from the Cisco web site, I found that the vrf TEST was actually traversing the 2 x MPLS-TE tunnels.The following commands helped me see this:-#show ip cef cef TEST#show ip ce...
After trying a fews things, I finally fluked it and got it to work. On the Cisco 4331 this is what I added:- bfd map ipv4 10.1.2.3/32 1.1.1.1/32 TESTbfd map ipv4 10.1.2.4/32 1.1.1.1/32 TESTbfd-template multi-hop TEST interval min-tx 100 min-rx 10...
Thanks for the quick response. The Cisco ISR4331 is 1 of many PE's. All the other PE's are Huawei AR3260's.I have attached a PDF document of the map.I hope this helps.
Hi Julian I tried the command "no mpls ip propagate-ttl" and it worked as descibed.No more intermediary steps. Thankyou for your assistance. Regards Michael
SpoilerHiIn relaion to the above issue, we decided to install the latest bundle.ie:- ir800-universalk9-bundle.SPA.158-3.M3.bin.While loading this new bundle into the IR829 router, we were told that there wasn't sufficient memory in the bootstrap memo...
