Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Call Recording 'Beep'.I have multi line phones- even though only recording on one of those lines all will BEEP. the beep is enables on the phone, individual lines have the actual recording enabled- where required. How can I solve this? CUCM 8.5.17961...
I cannot find anything that gives a short overview of what 'End Users' accomplishes in CUCM (8.5) I have seen a couple of things-1. Give phone users 'permissions' to do certain things with the phones (like custom Speed dial etc)2. Easy way to import...
We have Cisco Unity Express Version 7.1 Voice mail.I have a phone with multiple extensions on it.I want to have some of the extensions' voice mail show the Message Indicator Lamp on that phone. Line 1 2942Line 2 4002Line 3 3115 I want line 3 MWI to ...
I've been using the CNA for our 3560X type switches and really like it.I saw the lastest version would support the Sx300 switches. I tried it on some of our SF302-08P switches and it worked great!But then I tried it on a new one, with newer firmware ...
I have a remote site that the only telephone option is over the VoIP system.Currently, an ATA 187 is there, configured for two lines. Line 1 is setup for an analog phone- it works just fine.Line 2 is to be used with a Cambell Scientific modem (9600)....
Thanks! I have not had time to revisit this issue at all.I'll have to see our current setup.I didn't make a SIP trunk for those console phones (unlike the recording, which I needed to do). So I'll have to remember where to make trunk changes.Might b...
I want the beep for the recorded lines, just not the other lines. The only place I see the 'Recording Tone' is on the device.Not on the lines.On the lines there is the Recording Enable- but nothing about the beep. This phone has multiple lines... Mar...
No, I never did get this resolved.I didn't open a TAC and got busy putting other fires out and just haven't gotten back to it. I did get the phones (and radio enpoints) recording with our Eventide recorder from the Avtec console. Mark
thanks for the really quick help! Here is what we have:(call manager)Cisco Unified CM System version: 8.5.1 Voice mail (in our Gateway)Cisco Unity Express Version 7.1 The phone is SCCP.I've never done any command line in the CUE- just used the GUI. ...
