Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I upgraded from 6.1.3 to 10.5.1 (upgrade when fine used "drive to 9" then upgraded to 10.5.1). Now when I want to transfer a call I press transfer soft key it give a dial tone for a split second and puts the other call on hold and no option to dial a...
I have Anyconnect Essentials + the mobile license. I dont want mobile devices (like iPhones) connecting to my ASA just yet but may in the future. I know I can remove the mobile license but is there another way. (DAP will not work as I would need prem...
I am running 8.4(2) on ASA5585s. They are in mulitble context mode and set to transparent firewall with active/active failover. When I do a sh failover in a context I see 2 of my interfaces are (waiting). I have a BVI and these are...
I have a 3825 router running 12.4-11.XJ4. I want do bridge a vlan through it, config below. but it is not passing the traffic. I have a router connected each side of the bridge router one on each port g0/0.25 and g0/1.25. I just want to create a L2 l...
I have a test lab with the eval version of ACS5.2. I am running 802.1x on my switch to the ACS usinf radius and want to use my RSA token server to authenticate my users. I have setup my RSA server under "Radius Identiny Servers" in the external ident...
All I have figured out so far it that it seem to work fine if you are using NAT, I.E. the managemnt traffic will return via the mgmt interface and the internet will return via inside interface. The problem is I am not using NAT on my ASA and I think ...
I have the management-only command on the interface so maybe the traffice does not try to go back via the "inside" interface but how should get back to a host that is not on the 192.168.1.X/25 subnet? In this case my managemant PC is on a 10.1.0.X ad...
