Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,I think this is a pretty straight-forward ACS question. We're looking at setting up a new installation of ACS5.2, and there has been questions as to whether or not we can use the internal ACS administration accounts (System Administration --...
Hello all,I'm currently in the process of doing a bandwidth analysis on 2 WAN links at my current HQ / remote sites. The topology is pretty straightforward, two 3845 routers at HQ, and two 3845 routers at my remote site, both with P2P DS3 interfaces...
Hello all,We have purchased WAAS WAE 674 WAN Accelerator's, and I have a question on placement in our network. I've just recently implemented redundant WAN Lines (DS3's), and now would like to move my WAE674's so that they are accelerating traffic a...
All,Just wondering if there is a way to convert a CUCM publisher 7.1(2), to a subscriber without reloading the software entirely. Is there any way, without reloading the server to convert this server from a pub to a subscriber.I don't have a bootabl...
Looking for a recommendation. Question about load balancing between point to point WAN links. I'm currently looking for a solution to provide more network redundancy over my two point to point DS3 linesthat connect my remote site. I have 2 Cisco 3...
Joseph,Currently, I'm running equal cost load sharing (per destination, not per packet). It does look like there's a TCP throughput issue. From the quick tests I ran this morning using TTCP, this is what I'm seeing TCP vs UDP:C:\TCP>pcattcp -t X.X...
Understood, I've run through all 4 routers already, 0 CRC errors on my serial interfaces, not problems with the controllers etc.I'm in the process of getting some netmon tools, but I'm not sure they're going to show me exactly what i want to see.Than...
I agree with that assessment, I'm sure we have the 44.XX per DS3, so it does seem to be a throughput problem. We are a Vista shop (unfortunatley), until we migrate to Windows 7 in the coming months. I've tested disabling of the TCP auto-tuning whi...
Bhavin,Thanks! As someone who has only done the bare minimun with WCCP, it looks like the 3845 ISR's support GRE or L2 mode. What would be the difference between these two modes? I don't know what i'm running right now, we kind of took the stock c...