I have two networks spread across two locations, the current setup has a direct connection from the Primary site to the Secondary passing through the ISP with our router setup, we are the 2nd site's internet breakout, so all traffic comes out from ou...
A Cisco switch refresh was completed last year, each stack varies from a single switch to a stack of 6 using stack-wise. My concern is that we did not purchase or plug the "stack-power" cables into the switches. Still, when issuing "show stack-power ...
I have a customer who wants a basic switch config on a 2960. I have been configuring enterprise switches for my career, so I may need some pointers or recommendations. Their switches don't need any VLANs, all hosts will be on the same LAN and the DHC...
I have a Layer 2 campus, a core that does our routing and a distribution switch that connects to all our access switching. All vlans are carried by Tengig interface trucks and bundles into a L2 ether channel with LACP. A few instances I’ve added a vl...
My STP setup is to use the spanning-tree extend system-id, we have our distribution priority manually set to 24,576 with the system ID config, while the access layer uses the default priority.
