Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok I am wondering if the WS-3560X firmware will work on a WS-3560G-24TS switch? I know the 3560G has been EOL, but we still have a few and can't replace them for another year. I am trying to harden them a little more, but some of the commands are not...
Hey everyone,I am setting up a Radius (NPS) server, using MAC address authentication on my WLC 5508. The problem I am having is it is not allowing access. I get the following two events on my NPS.Event 1:Network Policy Server granted access to a user...
Hello everyone,I have a WLC 5508 I am trying to setup to use a Radius Server (MS NPS) on our WLAN to stop people from connecting to our Wireless Lan. This is already setup and being used for current WLAN. I have to pass this across all my WLC (which ...
I have a wireless network using WLC 5508 with AP 1815I's. The problem I am having is one computer (HP Laptop, Windows 11) will not stay connected to a specific AP. It will connect loose all signal and then disconnect. This computer works fine on a ho...
I am working on a mock-up of our network on packet tracer. Note IP address are not actual. We do not use a Cisco ASA in our setup but we have a firewall. I am not really familiar with the ASA, so I am having issues with YellowJacket2 getting to the i...
Arne,I get what you are saying now. I set the SSID to PSK instead of 802.1x, and now it seems to be connecting great on the one client I have registered, and not connecting on anyother device. Thank you for clarifying that for me.
What I am trying to do is get the device to connect to wifi only if the MAC address is in the windows user group. Using the MAC as the username and password. I don't want the user to have to input these. I know this takes a lot more work but that is ...
Arne,Yes, it is an Enterprise WLAN ID, the NPS is the RADIUS configured on the WLAN. The Device is a laptop which is the Supplicant. It is connecting through the WLC to the RADIUS.I followed this thread Solved: switch startup mode - Cisco Community t...
