Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently switched my Firepower setup from the legacy AD connector to ISE 2.7.0.356. One issue I am running into is that for my laptop ISE is reporting a different user account from my login when I view Live Sessions. This is causing issues for me whe...
Just unboxed a new UCS C220 M5SX and I was trying to log into the host and the passwords that are documented do not work. I have tried the following with the root account. Cisco, Cisco123, Cisco1234, Password (lower and upper on the first character) ...
Hello folks! I am currently running a two node cluster for Call Manager, Unity, and IM&P. I will be purchasing new hardware in the near future. What's the best practice to go about migrating the existing VM's to the new hosts? My Cisco hosts are sepa...
So we currently have 800 #'s that most of our customers use, these are translated on our 4300 routers using num-exp and a matching dial-peer to Call Manager. The DN in CUCM is set to forward to voicemail, which then goes to a System Call Handler. Tha...
I've looked around a bit and have not been able to determine if there will be disruption in mail flow during the creation of a cluster? I currently run the ESA virtual appliance and I have the new VM up and running and I have met all the requirements...
CIMC is working with the password I set, but the root password of password is not accepted and I can't change that since I am not able to access. I guess I am going to have to reinstall.
My existing dial-peer looks like this. I was wondering if I should change to this, dtmf-relay rtp-nte h245-alphanumeric h245-signal dial-peer voice 10 voippreference 2destination-pattern 4...progress_ind setup enable 3voice-class codec 100voice-class...
