I've N7K1 and N7K2, both have auto-recovery enabled.initial state:N7K1 - vPC primaryN7K2 - vPC secon...

please help.

Hello, Need help with sampled netflow explained in below link: https://www.cisco.com/c/en/us/td/docs...

i am upgrading n5600 vPC pair. there are unicast multicast hosts conneced behind this vPC pair. vPC ...

what is the difference between nexus 5500 and nexus 5600? Nexus 5500 is layer-2 only switch and we c...

how to find if nexus switch is using ntpv1? or receiving ntpv1 packets?

what's DUT?

Multicast: can host be source and receiver without pim BiDir? we have scenario where host is source ...

@Bhavin Yadav wrote:can you please specify what hardware you are talking about? Is this about MDS / ...

what is line rate and wire speed? what's difference between them?

what is vsh and bash on nexus? how it differs from cli?

n9k - vxlan - why store and forward switching? is it supposed to be cut through since store and forw...

how many FM does 9504, 9508, 9516 support? which slot # are these FM installed it?

Nexus switches - what is difference between mtu and hardware mtu? mtu that we configure using "mtu" ...

which N9K are EOR and TOR? what's the best way to classifly?