Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,My company is in the early stages of rolling out Win7 enterprise (64bit) with the CIsco 64bit VPN client (5.0.0.7.0290) for remote access back to our head office concentrators. We are seeing some strange occurences....1. In a few instances the...
Hi , can anyone advise? ...We have two data centres connected by a 2 pairs of active resilient ( diverse) 1Gbit fibre circuits. At each DC the circuits connect into a 3750E stack,each circuit connects to a different switch within the stack (interfac...
Hi,My company have recently installed a managed MPLS WAN service. In order to continue using OSPF as our routing protocol across our Wans I set up GRE tunneling on our routers. We need to implement COS/QOS for VIOP traffic However I am not particular...
I suspect the answer to the question is simply ?No? but you guys may know better The scenario is as follows: A wireless infrastructure with Cisco Aironet 1200 access points in over 50 different locations. Each location has a connection back to one ce...
HiI need some expert advice. I have been asked to provide a solution to the following. 20 remote sites with analog PSTN only require VPN access via the Internet to a central site.the devices within the remote sites which require this access are Point...
Hi Rudresh VThanks for your reply, I know it sounds unlikely but Wireshark definately affects the functioning of the VPN, it may be something to do with the WinPcap drivers which are used with wireshark. I've run lots of logs and found that when we...
Try this - it seems to create a second instance of the BVI 1 interface. ap#conf tEnter configuration commands, one per line. End with CNTL/Z.ap(config)#int bvI 1:0ap(config-if)#ap(config-if)#ip address 10.2.2.2 255.255.255.0ap(config-if)#endap#sh ip...
Try this - it seems to create a second instance of the BVI 1 interface. ap#conf tEnter configuration commands, one per line. End with CNTL/Z.ap(config)#int bvI 1:0ap(config-if)#ap(config-if)#ip address 10.2.2.2 255.255.255.0ap(config-if)#endap#sh ip...
Thanks for your reply Leo I can't use a software VPN client (no PC's are being used) but maybe a 3002 hardware client. Do you know much about setting up L2TP would that not addrerss the bandwidth issue. Would an ASA appliance terminate L2TP? Do you k...
