Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,My access switch has just rebooted automatically. What command should I use to find out the cause of the incident aside from show logs, show diagnostic?I need the data to provide to TAC.Thanks,Allen
You may run multiple OSPF processes on a single router, but take note that it creates multiple database instances that add extra overhead to the router.
Hi,It really depend upon you on what you'll be using if it's from lowest or largest but for me it's much more easier when you assign the largest first. Thanks,Allen
I suspected a software crash that cause the switch to reboot by itself but still your help was useful. I provided them the data that "more crashinfo:data" generated.
