Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am trying to redistribute bgp-learned routes from VRF to global.
However, I got the below message.
"Inter-VRF redistribution is NOT allowed from 'bgp'".
Since I am currently running it in VIRL, I wonder if this is a legit error message.
In my ...
Hi I am trying to figure out how to configure Layer 3 port-channel with subinterfaces.
This is my topology.
Two physical interfaces will be bundled into a single port-channel.
My CSR will act as a "Router On A Stick".
All interfaces on the switc...
Hi I have a Cisco ASR router with tengig interfaces.
Those tengig interfaces always remain up/up even though no cable is plugged and the switch on the other side shutdown the interface.
Is this a normal behavior of ASR?
How can I make the interface...
Hi, I have recently added a new AP in my office close to another AP, which are being managed by Cisco WLC.
Could you please give me a brief idea about how to optimize the radio frequency or channel utilization?
We've got 4 APs and two of them ar...
Hi, I am trying to understand how my customer's setup is working properly.
I told them it would not work, but they proceeded to buy the unmanaged switch and it is now working.
So embarrassing.
Here is a brief diagram of the setup.
Phone ---- Unmanag...
Hi Bradley,
I simply forgot to include there.
But in the actual config, there was "switchport mode trunk" command under the interfaces on the switch. Also, the keyword "native" was not included in the port-channel configuration.
Thank you
Hi Bradley,
Thank you very much for the detailed guide.
However, I also tried putting the port connected to iosv-1 into "switchport access vlan 101" and "switchport mode access", but got the same result.
I also created an "interface vlan 101" on ...
Thanks for the reply.
There is no Port-channel configuration for the switch, because the port-channel on the router is only used for the failover purpose.
