Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiIs there a way to stop IBNS 2 running on the switch or completely remove it so i can rebuilt it again, we have 2 switches in our environment showing a few status unknowns in the access sessions table for ports that are not even configured for IBNS2...
Hi I am running 1542 cisco access points as a mesh in an environment where vessels docks on 5gzh with a channel width of 80mhz for the best throughput for the client needs. lately the mesh network has been switch to 20mhz because it picking up radar ...
Hi i have two 1542 access point running 5ghz in mesh, i just want to find out what will be the max through put i would get between the Rap and Map. currently they only connect to each other via one 5ghz channel as that is the only option i see. than...
Hi Thanks for the feedback and to disable tracking on the port for 2960x switches running 152-7.E4 the command is "ip device tracking max 0" , but even with this the entries for IBNS 2 is still showing the sessions in its table after a reboot as well...
