Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening Everyone,
I followed the instructions on this page to setup a phone book search (installed and configured database, ...). When entering the URL
http://192.168.178.207/cisco/menu.xml
I noticed an "HTTP error" on the phone and nothing else...
Good morning everyone,
I have a question regarding ACLs on a Cisco 881.
In order to set ACLs on my inbound interface (Dialer 1) I wrote a set of access rules
access-list 111 permit icmp any any administratively-prohibitedaccess-list 111 permit icmp...
Good morning,
according to the CLI manual, release 1.4, page 980 ff. there is a "show environment" command similar to regular Cisco switches. When typing this command in the CLI there's a "Unrecognized command" error message.
Is there any way to get ...
Ladies and gentlemen,
we upgraded on of our routers a while ago from IOS12 to IOS15 and would like to migrate the SSL VPN license purchased for the 881 to a license suitable for IOS15.
When try to connect to https://tools.cisco.com/SWIFT/Licensin...
Hello there,after upgrading an ASA5520 from 8.4(1) to 8.4(4.1) I ran into the following trouble:Asymmetric NAT rules matched for forward and reverse flows; Connection for tcp src outside:192.168.149.21/53 dst inside:192.168.37.123/53 denied due to N...
Good afternoon and sorry for the delay.
As soon as I apply the very first ACL of the block mentioned above the traffic breaks down...
So sh access-list 111 is pretty clear...
I looked into the CiscoSB-Mibs and found only the PSU temp (OID .1.3.6.1.4.1.9.6.1.101.108.3.1.6.1) and the Temp status (OID .1.3.6.1.4.1.9.6.1.101.53.15.1.13.1).
Could get these infos via snmpget. So it's not the solution I was hoping for but better...
